Wet Sounds PRO 80 User Manual download pdf (Page 9)

Step 5: The detachment plate (5) will be hard mounted to a cast tower. Butt

connect speaker wires from detachment plate connector (4) to the speaker wires

from the cast tower. Red is positive and Black is negative.

Step 6: Push wires into center hole back into the tower and attach the

detachment plate to the tower.

Step 7: Please make sure the male speaker plug (7) and female speaker plug (4)

are lined up properly. The male speaker plug (7) inside the clamp base can

rotate. Please rotate this so that it is facing the proper direction. There is a U

shaped groove on the female that lines up with a boss on the male.

Step 8: Insert speaker with base onto detachment plate. Slide on detachment

fork (17) and allen bolt (19) and tighten allen bolt so the speaker does not

move.

Step 9: The swivel clamp also allows you to remove the speaker from the tower

in seconds. Loosen the allen locking bolt (19) and remove the detachment fork

(17). Once removed, the speaker will disconnect from the clamp. The

detachment plate remains on the tower. To reinstall, line up the male speaker

plug (7) so that it is centered and insert the speaker by plugging the connector

together and reinstalling the detachment fork.

1 2 3 4 5 6 7 8 9 10 11 12 13

No comments

Wet Sounds PRO 80 User Manual Page 9