Pipe Tower Mount Version using the TC3-S
Step 1: Attach Male Connector (10) from clamp base to Female Connector (11)
Step 2: Push connector into center hole of speaker as you place clamp base
onto the speaker housing. Insert 4 bare wires down into this hole as well. These
wires are only used if you are adding the LED speaker rings. (please see LED
speaker install instructions for LED install) Please make sure the grommet (12)
is seated properly.
Step 3: Attach two short Allen Bolts (16) through the clamp base and tighten
into the housing. Please make sure these are tight. It is also recommend to use
a Blue Loctite on these bolts.
Step 4: Clamp Bottom (3) and Detachment Plate (5) are already connected
together. Insert the detachment plate into the clamp base (9). Please make sure
the male speaker plug (7) and female speaker plug (4) are lined up properly.
The male speaker plug (7) inside the clamp base can rotate. Please rotate this
so that it is facing the proper direction. There is a U shaped groove on the
female that lines up with a boss on the male.
Step 5: Slide the detachment fork (17) into the grooves on the clamp base.
Attach the allen locking bolt (19) and tighten down.
Step 6: Find the mounting location for the speaker and clamp and then mark the
location on the bottom side of the pipe for the speaker wire. The speaker wire
will be inserted back into the pipe for a clean installation.
Step 5: Drill a small hole in the pipe and de burr the hole so there is no sharp
edges. It is also recommend to install a rubber grommet in this hole to protect
the wire.
Step 6: Slide the wire jacket (13) down the wire and Butt Connect the speaker
wire coming from the tower to the speaker wire plug (4). Red is positive and
black is negative. If you have added the LED accessory, this speaker wire plug
(4) will have 6 conductors. Please refer to the LED install instructions.
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals