Wet Sounds PRO 80 User Manual download pdf (Page 5)

Step 1: Attach Male Connector (7) from clamp base to Female Connector (8)

Step 2: Push connector into center hole of speaker as you place clamp base

onto the speaker housing. Please make sure the grommet (9) is seated properly.

Step 3: Attach two short Allen Bolts (4) through the clamp base and tighten

into the housing. Please make sure these are tight. It is also recommend to use

a Blue Loctite on these bolts.

Step 4: Find the mounting location for the speaker and clamp and then mark the

location on the bottom side of the pipe for the speaker wire. The speaker wire

will be inserted back into the pipe for a clean installation.

Step 5: Drill a small hole in the pipe and de burr the hole so there is no sharp

edges. It is also recommend to install a rubber grommet in this hole to protect

the wire.

Step 6: Slide the wire jacket (1) down the wire and Butt Connect the speaker

wire coming from the tower to the speaker wire plug (5). Red is positive and

black is negative

Step 7: Attach Clamp Top (3) to clamp base (6) using the two long Allen Bolts

(2)

Step 8: Make sure the clamp is tightened all the way so there is no movement

1 2 3 4 5 6 7 8 9 10 11 12 13

No comments

Wet Sounds PRO 80 User Manual Page 5